Sundown Audio SAX-100.2, Owner'S Manual

Page: 5 / 12

FUSE POWER SPEAKER
BRIDGE
B+ REM GND
Left Right
18dB 300Hz 2KHz 0dB 35Hz 75Hz
BASS
BOOST
CH1
OUTPUT
CH1
CH2 CH2
LPF HPF
INPUT
REMOTE
Max Min
SENSITIVITY
HPF LPF
FULL
Protection
Power
to INPUT of ADDITIONAL
AMPLIFIERS
to OUTPUT
of HEAD UNIT
RCA Connection
-5-
Power Connection
First make the ground connection, then +12V wire connection and
finally the remote connection. Furthermore, the +12V wire must
always be fused at the battery for protection against possible
damage. If you need to replace the power fuse, replace it with a
fuse of the same value. It may result in a serious hazard to use a
fuse of a different type or rating.
Caution
BATTERY
to REMOTE Turn-on
from HEAD UNIT
GROUND
To +12V DC
SAX-100.2
SAX-100.2
This amplifier utilizes RCA type low-level input terminals. Input level is set by
adjusting the "sensitivity" knob, which controls both channels. As illustrated
above the "Input" RCA pair is connected to the output of the radio via RCA to
RCA cables.
Wired Remote Controller
REMOTE
Connect the REM terminal to either the remote output lead from the radio or
another switched 12V supply such as the power antenna wire.
+12V Power
Connect the +12V terminal of the amplifier to the + terminal of the battery
using a large gauge power wire (preferably 4 gauge). It is critical to utilize
an in-line fuse within 8 inches of the battery to ensure safe operation of the
amplifier. Make sure that the fuse is not installed while you are connecting
the + wire to the battery terminal to avoid sparking and possible injury or
damage.
GROUND
Disconnect the battery and connect the GND (ground) terminal to the cars
chassis. Keep this cable as short as possible (not longer than 10 inches).
Be certain that the chassis ground point is free of rust, paint, and grime to
ensure a solid electrical connection.