5. Installation & Operation Guide
5.1 Description
This heater is equipped with our
built-in thermostat receiver -
Receiver01 - on the backside of the
panel. Before starting the installation,
we recommend you to pair the
receiver to our remote control as a
first step. Follow the guide bellow to
finish the pairing to the Smart control
system (e.g. Smart 1.0, Smart 1.0Pro
or Smartplug).
On the right see the drawing of the
signal lights and button of
Receiver01.
1)
Pair status signal light (
green light
)
2)
Heating status signal light (
red light
)
3)
“P” button
4)
Power switch
5.2 Pairing to Sundirect Smart control system
Step1: Plug your heater to an electricity outlet, switch the Power switch of Receiver01 on, double
press the “P” button and the
“Pair signal light”
will start to flashing and ready for pairing.
Step2: Power-off the remote control Smart 1.0/Smart 1.0Pro/Smartplug, long press the “SET” button.
The “PAIR” signal will show on the screen of the remote control. Wait until the
“Pair signal light”
stop flashing and glow green to finish the pairing.
Now the pairing process is finished and the
Receiver01 will only be commanded by the Smart controller.
Note:
After the paring process and once Receiver01 and Smart 1.0/Smart 1.0Pro/Smartplug are
paired, the pair signal light will always be on and the Receiver01 will be only commanded by the
Smart 1.0/Smart 1.0Pro/Smartplug. One Receiver01 can only pair to one controller, however, One
controller can be paired to several Receiver01 if they are in the same room.
5.3 Extra Safety Protection:
The heater is equipped with the Sundirect “Extra Safety Protection” function, which will automatically
turn off the heater if it lost the signal from the Smart controller for more than one hour. And it will
be automatically connected once the Smart controller is within the communication distance.
6
