Email: [email protected]
Facebook: #SundayLiving
7
3.Setting heat
Under standby mode, press Heater button to start heater.
Or
Under standby mode, press the Heater button on the control panel or
remote control, the heater will start (The heater indicator is under the
artificial charcoal set. When heat is on, the charcoal set will be lit up and
flicker automatically at a slow pace). Press the Heater button again. Heat
and heater indicator will be off while fan will prolong working for 30
seconds to emit plenty of heat inside.
Caution: When the flame is on, the heater indicator will keep lit-
up if you turn off the heat.
4. Setting flame
Under standby, press the Flame button to watch the flame effect.
Or
Under standby, press Flame button, the flame will be on at brightest. The
charcoal set will be lit up and flicker automatically at a slow pace. Each
time this button is pressed, the intensity of the flame decreases. There
are five brightness levels you can cycle through including the OFF setting.
Caution: When the heat is on, the charcoal set will keep lit-up if you
turn off the flame.
MAINTENANCE
1. Turn off the heater of the power switch.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild
detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the
heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This
may cause damage or deterioration to the surface of the heater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.
7. If won
’
t use the unit for a long time, please take out battery in remote control according to following steps,
then take care of the remote control.
