SunDanzer DC50 User Manual Download Page 3

IMPORTANT SAFETY INSTRUCTIONS 

 
These warnings are provided in the interests of your safety.  Please ensure that you understand them all before installing 
or using this appliance.  Your safety is of paramount importance.  If you are unsure about any of these meanings or 
warnings, contact SunDanzer or your local product dealer for assistance.   
 

Prior to Installation 

 

At the delivery, please check that the appliance is complete and has not been damaged during transport. It is not 
advised to connect an appliance that has been damaged, especially damage to the electrical supply cable or 
refrigerant circuit.  In the event of damage please contact SunDanzer or your local product dealer for assistance.  

 

General Safety 

 

Before cleaning or repositioning the appliance, always disconnect from the electrical power supply. 

 

Service the appliance only if you are a trained or authorized refrigeration technician.   

 

This appliance contains refrigerant R-134a and a polyol-ester compressor oil in its refrigerant circuit. Take utmost 
care when handling your appliance so as to not cause damage to the refrigerant circuit with consequent possible 
leakage. 

 

Do not use other electrical appliances (such as ice cream makers) inside of the refrigerating appliance. 

 

Child Safety 

 

There is a DANGER OF SUFFOCATION if a child becomes trapped inside!

  

 

Keep children from playing in, on, or around this appliance.   

 

When the unit is not in use, please secure or remove the lid to prevent children from playing inside the cabinet.

 

 

Keep children away from the packaging material.  DANGER OF SUFFOCATION!

 

 

Installation 

 

This appliance is heavy.  Care should be taken when moving it. 

 

This appliance operates on 

12 or 24 Volts DC

 (Direct Current) only!

   

 

Under no circumstances should this appliance be directly connected to an AC (Alternating Current) power 
source. 

 

Be sure that the appliance does not stand on the electrical supply cable. Also, be sure the electrical cable is not 
squeezed or bent when the appliance is being installed or moved. 

 

Installation work and adjustments on the appliance must be carried out by qualified personnel only.  Work 
performed by persons with inadequate technical knowledge may adversely effect the performance of the appliance, 
causing damage to the equipment, and void the warranty. 

 

It is dangerous to make alterations or attempt to modify this product in any way.  Product alterations will void the 
warranty. 

 

During Use 

 

This appliance is designed for domestic use only!

  Specifically for the storage of food and drinks (foodstuff).  

This appliance is not designed for commercial or industrial use.   

 

Do not store any containers with flammable vapors or liquids in or around the appliance, such as organic solvents, 
spray cans, gas cans, etc

.  Danger of explosion!

  

 

Cleaning 

 

Before cleaning always disconnect from the electrical power supply. 

 

Servicing 

 

This product should be serviced by an authorized technician and only genuine spare parts should be used. 

 

Under no circumstances should you attempt to repair the appliance yourself.  Repairs carried out by inexperienced 
persons may cause injury or serious malfunctioning of the appliance. Unauthorized work may void the warranty. 

 

 

Rev. 05/21/08 

3

Summary of Contents for DC50










Reviews: