Version 1.1.1
Page 38 of 38
SMT398 User Manual
D0-D7 2,4,6,8
10,12,
14,16
Data Bus
— This pin is used for Virtex SelectMAP Mode. An
8-bit data bus supporting the SelectMAP and Express
configuration modes.
CS0 (CS)
1
Chip Select
— CS on the Virtex.
The CS0/CS pin represents a chip select to the target FPGA
during configuration.
RS
(RDWR)
13
Read Select
— The RS pin represents Read Select control for
the Asynchronous Peripheral configuration mode.
Read/Write
— The RDWR pin is used as an active high READ
and an active low WRITE control signal to the Virtex FPGA.
RDY/BUSY 15
Busy Pin
— Busy pin on the Virtex.
Table 11: Connector J12 Flying Lead Sets 3&4
Safety
This module presents no hazard to the user.
EMC
This module is designed to operate from within an enclosed host system, which is
build to provide EMC shielding. Operation within the EU EMC guidelines is not
guaranteed unless it is installed within an adequate host system.
This module is protected from damage by fast voltage transients originating from
outside the host system which may be introduced through the output cables.
Short-circuiting any output to ground does not cause the host PC system to lock up
or reboot.
Summary of Contents for SMT398
Page 1: ...SMT398 User Manual...
