Sunco SH3000 Use & Care And Installation Manual Download Page 2

CAUTIONS

 

 

READ

 

THIS

 

FIRST

 

Page 1 

0B

For Your Safety… 

Your Sunco wood heater has been designed and tested to rigorous Australian Standards, and will provide 
you with beautiful, environmentally sustainable home heating for many years. However, we must 
remember that these appliances are very powerful, and need to be both installed correctly and operated 
with care.  

10B

WHAT

 

TO

 

BURN

 

Burn only dry, seasoned hardwood in these heaters.  

Do not use flammable liquids or spray aerosols to help start the fire, or at any time the fire is operating. 

Do not burn the following: 

 

Treated timbers (eg treated pine or painted fence palings) as these will emit poisonous chemicals. 

 

Household refuse 

 

Coal or briquettes 

 

Combustible building materials 

as these materials either emit hazardous chemicals or will cause a dangerous build up of soot and 
creosote in your flue, which may cause a dangerous flue fire. 

11B

WHAT

 

TO

 

KEEP

 

AWAY

 

FROM

 

THE

 

HEATER

 

Do not store or use petrol, kerosene, methylated spirits or other flammable liquids in the vicinity of this 
appliance (ie within installation clearances). 

Keep all combustible material, including curtains, furniture, wood, paper and matches, away from the 
heater. Observe the clearances in the installation section. 

Supervise young children to ensure they do not play with the appliance. Keep children away from the 
heater when it is alight. For young children, a secondary guard or fire screen is recommended. 

This appliance is not intended for use by persons (including children) with reduced physical, sensory or 
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or 
instruction concerning use of the appliance by a person responsible for their safety. 

12B

ENSURE

 

THE

 

HEATER

 

IS

 

IN

 

PROPER

 

WORKING

 

CONDITION

 

Do not use this heater with a cracked glass. The glass should be replaced only with genuine ceramic glass 
from the manufacturer. 

This appliance or flue must not be modified in any way without written permission from the 
manufacturer. Failure to observe this requirement will void the warranty, and may void household 
insurance. 

If you have had a flue fire, have the heater and flue inspected before it is used again. 

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a suitably 
qualified person in order to avoid electrical hazard. 

Summary of Contents for SH3000













Reviews: