QUICK START
1. Make sure the SPEAKER VOLUME [8] control is down before your turn the
POWER [14] on.
2. Connect the output of your microphone to the MIC IN [1]. Or you can connect a
¼” line input from an instrument [2]. Connect an additional mono or stereo [4]. A
direct USB connection can be made via the USB port [16].
3. Connect the DC power cord to the back panel [14].
4. Turn on the POWER [14] switch
5. Turn on your source signal(s) and adjust the volume on the source signal for
normal operation. Note if you are using an iPhone or iPad via Bluetooth®, set the
volume on your device about halfway. Maximum volume will distort.
6. Adjust the SPEAKER VOLUME [8] to a comfortable level.
7. Turn up GAIN [3] and TRIM [5] until there is a solid green light showing “signal” at
desired level, without a red “peak” light, indicating too much signal.
8. For USB charging of your source device, use USB Port [15]
Power LED:
BLUE [9] Indicate unit is ON
Channel 1 [12]
Pan: split signal into Left/Right channel
Level: Volume Control
Peak LED: RED indicate Signal Clip
Signal LED: GREEN indicate Signal Present
Speaker
Speaker Volume [8]: Control speakers’ volume level
Equalizer [10]: Adjust Speaker High, Mid, and Low Frequency response
Peak LED [9]: RED indicate Signal Clip
Signal LED [9]: GREEN indicate Signal Present
Aux Input/Level [11]:
Connect audio source with 1/8” jack from MP3/CD player
Channel 1 input:
Gain [3] knob: Input Level control
Line In [2]: 1/4” TRS inputs
Mic In [1]: XLR for Microphone Input
Channel 2/3 input:
Trim Knob [5]: Input Level control
Left/Right channel input [4]: 1/4” TRS inputs
Main Right to SPK switch [6]:
Right channel signal. When the button is up, only the
Right channel mono signal is sent for connection to the L (mono) of additional speaker.
Main Right Output [6]:
Connect with extra speakers/monitors
BLUETOOTH® FUNCTION(NOT AVAILABLE ON M3R8, MM3P)
•
To turn ON/OFF Bluetooth® function
PRESS/HOLD down MODE button for approximately 5 seconds
Both LEDs will flash at the same time
•
To pair device to the speaker system
Bluetooth® needs to be turned ON
QUICK TAP the MODE button once
Both Flashing LED: indicate Bluetooth ® is ready to be paired
Flashing Blue LED only: indicate Bluetooth® is connected