4
Using your Water Filter
& Chiller
Before using your Water Filter
& Chiller
• Carefully unpack the appliance and check
that all the components are included.
Please refer to pages 2-3.
• Remove the filter cartridge and put to one
side.
Do not re-insert until (a) flushing process
and (b) preparation of filter cartridge
procedures, as explained below, have been
completed.
• Wipe out the filtered water tank with a
damp cloth which has been soaked in
water.
• Position the appliance on a dry, level and
secure bench top. Allow for good airflow
around the appliance so do not place
directly against a wall.
• Do not position the unit in an area that
receives direct sunlight. Placing the unit in
direct sunlight may affect unit performance
as well as promote the growth of algae.
Flushing Process
• It is important that you flush and rinse out
the dispensing system before using the
appliance for the first time.
• Fill the water tank to the brim with hot tap
water.
• Place a large container or jug under the
spout.
• Press the dispenser lever until all the water
is dispensed and the water tank is empty.
• Repeat this flushing process twice with
cold tap water and discard.
• Please note that when flushing for the first
time, while pressing the dispensing lever,
no water will be dispensed until the tank
is almost empty as it will be filling the
chilling tank.
• Do not fill above the maximum level
indicated.
• Please note that you should carry out these
steps without the Maxtra cartridge in place.
• Plug the appliance into an appropriate
electrical outlet and switch on.
• A white power on light will be illuminated
to show that the appliance is switched on
and working.
