![background image](http://html1.mh-extra.com/html/sunbeam/sb1800/sb1800_operating-instructions-manual_1394709005.webp)
Sewing Machine Instructions
Page 5
to the right, clicking it into
place. (Figure 5)
Select a speed switch. This
5.
will start the bobbin winding.
(Figure 6)
When you have your desired amount of thread
6.
on the bobbin, switch to OFF and move the
bobbin to the left (Figure 7) snip the thread.
(Figure 8)
Note:
It is preferable to manually assist in the
winding of the bobbin. Use your hands to guide the thread.
Threading the machine
Make sure that the power switch is on OFF.
Place a spool of thread on the Spool Pin with
1.
the thread end facing rear. (Figure 9)
Clamp the reel cover over the Spool Pin so
2.
that the thread remains in place. (Figure 10)
Loop the thread around the outside of thread
3.
guide 1. (Figure 11)
Guide the thread into Groove 2, and pull
4.
toward the chrome take-up
lever. (Figure 12)
Feed the thread through the
5.
hole in the chrome take-up
lever and pull straight down
to the needle. (Figure 13)
Figure 11
Figure 12
Figure 10
Figure 9
Preparations for Use
Plug one end of the adapter into the DC socket on the sewing
•
machine, and the other end into an outlet.
Plug the foot control into its socket.
•
Turn the power switch on.
•
Caution:
Always turn the switch on off before un-plugging the
machine.
Operating Instructions
Winding the bobbin
Place a spool of thread on the Spool Pin.
1.
(Figure 1) (Make sure that the machine’s
needle is not threaded at this time.)
Place the metal bobbin on the bobbin winder,
2.
making sure to insert it in the groove. (Figure
2) (Note: It is important to use metal bobbins
only. The Bobbin Case is magnetized and is
activated with metal.)
Guide the thread from the Spool Pin through
3.
the thread clamp (Figure 3) and to the bobbin.
Wind a small piece of thread around the
bobbin
clockwise.
(Figure 4)
Move the
4.
bobbin
Figure 8
Figure 6
Figure 7