Instructions Manual
Page 3
Hold the sewing machine with right hand and operate power switch with
thumb, other fingers supporting the bottom.
Unlock the sewing machine. Press the power switch with your right thumb.
The machine will automatically sew the fabric/cloth to the left (
Figure 6
).
Use the left hand to hold cloth and control the direction (do not rush the
machine). When wider stitches are required, pull cloth to the left a little
faster while you continue sewing.
Follow the centerline on cloth fastening plate to ensure straight stitching.
To finish seam, raise the needle arm to the highest position by turning the
rotary wheel. Use the back of a seam ripper or scissors to pull the thread out
about three inches then cut it (
Figure 7
).
Turn the rotary wheel, lowering the needle into the cloth. Continue to turn
the rotary wheel until needle arm is again at its highest position.
Lift up the fastening plate and take off the cloth to the left (
Figure 8
),
making sure not pull the thread out the seam doing so can cause the seam
to unravel.
Turn to backside of the cloth and guide the reserved 3 inches according to
the following figures to make the knot (
Figure 9
):
1.
First pass threader through the last stitch.
2.
Put the reserved 3 inch thread through the threader hole.
3.
Pull it out about 1 inch.
4.
Guide the thread through the loop and pull it tight to finish the knot
.
Note:
The spring must be in place before installing bobbin. Thread should
flow from the top right of the bobbin or spool.
Pass thread through the eyelet on the needle arm (
Figure 10
).
Threading the Machine:
Summary of Contents for SB011
Page 1: ......
