Sunbeam KE9400, Instruction Booklet

Page: 6 / 12

4
Using your Sunbeam Kettle
Before using your kettle
It is recommended that you clean your kettle
before first use by filling the kettle with
water, up to the maximum level indicator,
boil and discard.
Using your kettle
1. To fill the kettle, remove it from the power
base. Remove the lid by turning it anti
clockwise.
2. Fill the kettle with the desired amount of
water. Always fill the kettle between the
minimum and maximum marks.
NOTE: Do not fill the kettle over the maximum
level, as water may spill out of the spout
when boiling.
3. Replace the lid and lock it into place by
turning it clockwise. Ensure the filter is
facing the front of the kettle and in line
with the tip of the spout.
NOTE:
The lid is not locked into place if the
filter is not facing the front of the kettle and
in line with the tip of the spout
4. Place the kettle on the power base.
Connect the plug into a 230/240 Volt AC
power outlet. Turn the power ON.
5. Touch the Power/Boil button. The button
lever will illuminate to indicate the kettle
is heating. The kettle will switch off
automatically once the water has boiled.
IMPORTANT: Ensure that the lid is firmly in
place.
NOTE:
Boiling can be interupted or cancelled
at any time simply by lifting the kettle from
the power base or pressing the button.
6. Lift the kettle from the power base and
pour the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will scald.
7. The kettle may be stored on the power
base while not in use.
NOTE: Ensure the power is turned off at the
power outlet when the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, boil-dry protection
will automatically switch it off. If this occurs,
allow the kettle to cool before filling with
cold water and re-boiling.
Cord Storage Facility
Excess cord can be stored by winding up the
desired length of cord into the storage facility
inside the power base.