• Remove all packaging
• Ensure the power button on the controller is
in the off position (not pressed in)
• Connect the controller to the heat pad
• Insert the plug into the power outlet and
switch on
• The heat pad will automatically default to
setting 5 for rapid heating, and begin to
heat up.
• Setting 5 is for heat up only. Do not use this
setting for continuous or overnight use.
• Place the heat pad behind your back or neck
whilst sitting or lying on a couch, chair or
bed. This versatile heat pad is
• a cozy and comfortable addition to any
lounge or bedroom.
• You can use the sleeve to secure the heat
pad to a chair back or around your arm or
leg.
• To reduce the warmth, switch to a lower heat
setting. For any continuous or overnight use,
select from settings 1-4 only.
Note: If the blue standby indicator light
on the controller begins to flash, turn the
controller off and check that the controller
is properly connected to the heat pad. If the
blue standby indicator continues to flash after
turning the controller back on, contact your
local Sunbeam Service Agent.
• The heat pad features an auto shut off. After
3 hours operation, the blue standby indicator
light will show to indicate the heat pad has
switched itself off.
This Feel Perfect heat pad features waterproof
heating elements, making them fully immersible
and safe to wash by hand or machine.
Before
cleaning your heat pad, ensure that the controls
are unplugged from the heat pad.
Spot cleaning
Sponge the affected area using a neutral
wool detergent or mild soap flakes mixed with
lukewarm water. Sponge twice with clean water
to remove detergent. Remove excess water by
compressing the wet area between two towels.
Hand washing
Wash the heat pad in lukewarm water with a
neutral wool detergent or mild soap flakes. Soak
for five minutes, then gently squeeze the soapy
water through the fabric. Rinse thoroughly in
clean, lukewarm water then drain excess water
from the heat pad. Do not wring.
Machine washing
Take your heat pad to a commercial laundry or
wash in a domestic washing machine. Wash on
WOOL or DELICATES cycle with a neutral wool
detergent or mild soap flakes, below 40°C. Do
not use high speed or extra spin cycles.
Line drying
Drape the heat pad across several lines of your
clothesline. Do not use pegs on the wired areas.
Do not dry with a hairdryer or heater. Ensure
that the heat pad and control sockets are
completely dry before using again.
Machine drying
Tumble dry your heat pad on LOW setting for 15
minutes MAXIMUM. Smooth the heat pad by
gently pulling any creases out of the fabric. Line
dry to ensure the heat pad and control sockets
are completely dry before use. Do not dry with a
hairdryer or heater.
Storing your heat pad
Roll or fold your heat pad loosely and store in a
blanket bag or the bag it was supplied in. Avoid
pressing sharp creases into the heat pad. Do not
place heavy items on top of your heat pad when
storing.
Checking your heat pad
Examine the heat pad frequently for signs of
wear or damage. If there are any such signs or
if the heat pad has been misused, return it to
your nearest Sunbeam Service Agent prior to
any further use.
Using your Heat Pad
Auto off function
Care and Cleaning
Using your Heat Pad
7
6
