6
7
•
Before cleaning the air purifier, always
turn OFF and unplug the unit.
•
Clean the exterior surface with a clean,
damp cloth.
•
The top air outlet vent can be cleaned of
dust with a small, soft brush.
•
If you would like to clean the inside of
your filter compartment, ONLY use a
dry, soft cloth to wipe it down.
WARNING:
Do not allow moisture to come
into contact with the main housing of the air
purifier. NEVER use detergents, gasoline,
glass cleaner, furniture polish, paint thinner,
or other household solvents to clean any
part of the appliance.
Open the small door compartment and use a
vacuum cleaner for about 10 seconds at the
lowest speed setting.
It is recommended to do this once every two
months.
Care and maintenance
Air quality sensor maintenance
How to replace the True HEPA filter
It is recommended to replace the 3-in-
1 True HEPA filter every 12 months
depending on usage.
1. The filter replacement indicator light
and air quality indicator will flash when it’s
time to replace the filter.
2. Turn OFF and unplug the air purifier.
3. Locate the filter cover on the bottom of
the unit.
4. Rotate the knob counterclockwise to
remove the cover and expose the filter
(Figure 1-2 on the previous page).
5. Remove and discard the filter and
re-insert a new filter (Figure 3 on the
previous page).
6. Re-align the filter cover and turn the
knob clockwise to close.
7. Plug the unit and turn the power ON.
8. To reset the filter status on the
air purifier, press & hold the filter
replacement button
for 3 seconds.
The filter icon
will Flash 3 times and
then go off.
Information on where to purchase
replacement filters can be found on our
website at www.sunbeam.com.au.
WARNING:
Only use the original Sunbeam
filter model SAPF360D specially intended for
this appliance. Do not use any other filters.
For troubleshooting and FAQs visit
www.sunbeam.com.au
.
Problem
Cause
Solution
The air purifier
is not working.
The appliance is not plugged
in.
Check if unit is properly plugged in and
outlet is working.
The appliance is not switched
on.
Make sure unit is turned ON.
The filter is not properly
installed.
Make sure filters are properly installed.
The filter cover is not fully
assembled.
Check that the filter cover is correctly
assembled by re-aligning the filter
cover and turn the knob clockwise to
close.
The air flow has
decreased.
The air intake grille and
filtered air outlet may be
obstructed.
Turn OFF and unplug the appliance.
Remove any obstructions blocking the
air intake grille, fabric pre-filter and
filtered air outlet.
The filter is nearing the end of
its useful product life.
Check the condition of the filters and
replace if necessary.
Pre-installed filter is covered
by a protective plastic
packaging.
Check filter to remove any plastic
packaging and re-install the filter.
The air purifier
is making a
loud noise.
Pre-installed filter is covered
by a protective plastic
packaging.
Check filter to remove any plastic
packaging and re-install the filter.
The ioniser may produce
an occasional popping or
cracking sound.
This is normal and occurs when a
small buildup of ions is discharged.
Troubleshooting and support
Step 1.
Open the air quality
sensor cover.
Step 2.
Clean air quality sensor, air
inlet, air outlet and lens with
vacuum cleaner.
Step 3.
Reattach the air quality
sensor cover.
