CARE AND CLEANING
FILTER REMOVAL/CLEANING/REFITTING
IMPORTANT: The kettle must be switched OFF, disconnected
from the power outlet and allowed to cool down completely
prior to removing or refitting the filter. Do not use excessive
force, as this might damage the filter or the lid.
1. Empty the kettle and open the lid.
2. Hold the lid open with one hand and grip the top part of the
filter with index finger and thumb.
CAUTION: Keep fingers
clear of mesh. Pressing into mesh may damage filter.
3. To remove filter simply pull upwards. This will disengage the
filter from its guides.
4. To clean the filter, rinse under a tap while brushing it gently
with a soft brush.
5. To refit filter, once again hold lid open with one hand and filter
with index finger and thumb. Gently push filter back into the
kettle until it fits snugly in its guides. Be sure to fit the bottom
lip of the filter snugly in the center guide. This will center the
filter in the spout, ensuring a good fit.
6. Rinse out kettle with fresh water and it’s ready for use.
E7
and the electric kettle will switch off automatically when the
water has boiled.
NOTE: Ensure the ON/OFF switch is clear of obstructions
and the lid is firmly closed. The electric kettle will not turn
OFF automatically if the ON/OFF switch is constrained, or
if the lid is left open.
4. Carefully lift the kettle and pour the boiling water.
NOTE: The kettle will not re-boil until the ON/OFF switch
is again switched ON. Wait 15-20 seconds, allowing kettle to
cool down, then switch ON.
BOIL DRY PROTECTION
If the kettle is operated in accordance with instructions for use,
it is unlikely that the kettle will boil dry. However, in the event
that the kettle does boil dry, it is protected by a boil dry, fail-safe
device which will switch the kettle OFF automatically on sensing
a boil dry situation and keep it switched OFF until the kettle is
refilled with at least the minimum amount of water. Always allow
the kettle to cool for half an hour before reuse if the kettle has
boiled dry.
E6
