How it Works:
The Sunbeam® Advanced Bark Control Collar has a proprietary bark
detection system that uses sensors and a voice mapping system to
determine barking behavior. This specially designed system ensures that
a correction is administered only when unwanted barking behavior is
occurring. The system also has been designed to prevent continuous
corrections if excessive barking is detected.
OVER CORRECTION MODE
causes the system to turn off and automatically reset.
OPERATING INSTRUCTIONS
Battery Installation:
IMPORTANT:
This step is to be completed
when the collar is NOT
on your dog.
• Remove two screws securing the battery
compartment using a cross head or
Phillips head screwdriver. (
fig. 1)
• Lift battery compartment from main body
of bark collar. (
fig. 2)
• Insert two CR2032 Lithium coin batteries
into battery compartment. Batteries
should be placed with the positive side
facing down.
IMPORTANT:
Follow orientation as
described on graphics illustrated on battery
compartment. (
fig. 3)
• Replace battery compartment with two
CR2032 Lithium coin batteries back
into main body.
Note:
The battery
compartment can only be assembled in
one orientation, do not force closed.
• Tighten the two screws using the cross
head screwdriver, do not over tighten.
• To test the unit, turn on by pressing and holding the main control button
for 4 seconds. The unit will beep twice and flash twice, leaving one LED
illuminated to indicate which correction level is in use. LED will turn off
after 10 seconds.
• To turn off the unit, press and hold the main control button for 4 seconds.
The unit will beep twice and flash twice, leaving no LEDs illuminated,
indicating the unit is off.
figure 1
figure 2
figure 3
3