Note: to take the door off it is necessary to tilt the appliance backward.
You should rest the DC Refrigerator on something solid.
DO NOT lay the appliance completely flat as this may damage the
coolant system
1.
Remove the screw cover. Undo the screws and remove the top
cover and hinge bracket
2.
Slide the fridge door up and lift away from the appliance
3.
Undo the screws of the middle hinge. Slide the freezer door up
and lift away from the appliance.
4.
Undo the screws and remove the bottom hinge. Screw it into
place on the new side and replace the adjustable feet.
5.
Remove the pin from the fridge and freezer doors. On the
opposite bracket, insert the replacement hinge pin. Ensure the
pin is secure.
6.
Place the freezer door first and screw the hinge on the opposite
side.
Note:
Ensure the door is aligned horizontally and vertically and that
the seals are closed on all sides before finally tightening the middle
hinge.
7.
Place the fridge door first and screw the top hinge on the
opposite side.
Note:
Ensure the door is aligned horizontally and
vertically and that the seals are closed on all sides before finally
tightening the top hinge.
Important:
Double check that the door is aligned correctly and all the
seals are closed on all sides. If necessary, re-adjust the leveling feet.
CABLE REQUIREMENTS
To ensure the correct start and operating conditions for the DC Refrigerator,
the following cable dimensions must be observed:
Wire Sizing Chart
(Gauge)
Max. length between battery and
compressor (ft)
12V/DC
24V/DC
# 10
15 ft
30 ft
# 8
20 ft
45 ft
# 6
30 ft
60 ft
# 4
45 ft
100 ft
Operating Your Refrigerator/Freezer
Switching on your DC Refrigerator
1.
Before connecting the appliance to the DC power supply, make sure
that the thermostat control dial is set at position 0. This is located on
the right part of the fridge.
2.
Turn the thermostat knob clockwise to set it to the desired position.
Bear in mind that the higher the number, the colder the temperature.
3.
To ensure that the appliance is cool enough to sufficiently chill your
food wait 24 hours before filling with food.
Adjusting the temperature
The internal temperature of your appliance is controlled by a thermostat.
Position 7 makes the appliance coldest and position 1 makes it warmest and 0
turns the appliance off. The recommended setting for the appliance is
between 1-4 for colder working environment (i.e. during winter) and 4-6 for
hotter environments. The temperature of the appliance may not operate at
the correct temperature if it is in a particularly hot or cold room or if you open
the appliance door often.
Page 7
Page 4
Summary of Contents for ST-6RF
Page 1: ...Copyright SunStar 2017 Model ST 6RF Owner s Manual...
Page 2: ......
