Sun Oracle Netra SPARC T3-1B, Service Manual

Page: 57 / 136

Detecting and Managing Faults 45
The following ASR commands enable you to view and add or remove components
(
asrkeys
) from the ASR blacklist. You run these commands from the Oracle ILOM
->
prompt.
Note – The
asrkey
values vary from system to system, depending on how many
cores and memory are present. Use the
show components
command to see the
asrkey
values on a given system.
After you enable or disable a component, you must reset (or power cycle) the system
for the component’s change of state to take effect. See the
SPARC T3 Series Servers
Administration Guide
Related Information
■
“Display System Components” on page 45
■
“Disable System Components” on page 47
■
“Enable System Components” on page 48
▼
Display System Components
The
show components
command displays the system components (
asrkeys
) and
reports their status.
●
At the -> prompt, type the
show components
command.
In the following example, one of the DIMMs (
BOB1/CH0/D0
) is shown as
disabled.
TABLE:
ASR Commands
Command Description
show components
Displays system components and their current state.
set
asrkey
component_state=
Enabled
Removes a component from the
asr-db
blacklist,
where asrkey is the component to enable.
set
asrkey
component_state=
Disabled
Adds a component to the
asr-db
blacklist, where
asrkey is the component to disable.
-> show components
Target | Property | Value
--------------------+------------------------+-------------------------------
/SYS/MB/REM | component_state | Enabled