Sun Microsystems x4422a, User Manual

Page: 49 / 96

Chapter 3 Configuring Driver Parameters 31
Operational Mode Parameters
The following parameters determine the transmit and receive speed and duplex.
TABLE 3-2
describes the operational mode parameters and their default values
Note –
If a parameter’s initial setting is 0, it cannot be changed. If you try to change
it, it will revert back to 0.
TABLE 3-2
Operational Mode Parameters
Parameter Description
adv-autoneg-cap
Local interface capability advertised by the hardware
0 = Forced mode
1 = Autonegotiation (default)
adv-1000fdx-cap
Local interface capability advertised by the hardware
0 = Not 1000 Mbit/sec full-duplex capable
1 = 1000 Mbit/sec full-duplex capable (default)
adv-1000hdx-cap
Local interface capability advertised by the hardware
0 = Not 1000 Mbit/sec half-duplex capable
1 = 1000 Mbit/sec half-duplex capable (default)
adv-100T4-cap
Local interface capability advertised by the hardware
0 = Not 100T4 capable (default)
1 = 100T4 capable
adv-100fdx-cap
Local interface capability advertised by the hardware
0 = Not 100 Mbit/sec full-duplex capable
1 = 100 Mbit/sec full-duplex capable (default)
adv-100hdx-cap
Local interface capability advertised by the hardware
0 = Not 100 Mbit/sec half-duplex capable
1 = 100 Mbit/sec half-duplex capable (default)
adv-10fdx-cap
Local interface capability advertised by the hardware
0 = Not 10 Mbit/sec full-duplex capable
1 = 10 Mbit/sec full-duplex capable (default)
adv-10hdx-cap
Local interface capability advertised by the hardware
0 = Not 10 Mbit/sec half-duplex capable
1 = 10 Mbit/sec half-duplex capable (default)