5
FIGURE 2
Removing the Memory Riser Assembly
Note –
The torque-indicator driver included with your system is shipped in the
green holder that is stored in the center of the hard drive cage.
6. Lift the memory riser assembly from the chassis and lay it on an antistatic mat
with the DIMM slots facing upwards.
Caution –
Hold DIMMs only by their edges. Place DIMMs and the memory riser
assembly on an antistatic mat whenever you set them down.
Caution –
If you do not seat the DIMM into its slot evenly, it can cause shorts that
will damage the system. Follow the procedure below and refer to the illustration at
right to seat the DIMM properly.
Failure to comply with these instructions can result in damage to system
components or assemblies and can void the warranty.
7. Hold the DIMM at the top left and right corners using the thumb and index finger
of each hand.
Note –
Be sure you are holding the DIMM straight and parallel to its slot.