Sun Microsystems Sun StorEdge T3, Installation, Operation And Service Manual

Page: 72 / 148

2-34 Sun StorEdge T3 Disk Tray Installation, Operation, and Service Manual • July 2000
■
none
indicates that there is no standby (hot spare) disk drive.
The physical location of the disk drives is shown in
FIGURE 2-16
.
FIGURE 2-16
Disk Drive Physical Numbering
■
If you want to change the default configuration, do not continue with this section.
Instead, refer to the Sun StorEdge T3 Disk Tray Administrator’s Guide for
information on how to remove the default volume and reconfigure the disk
drives.
■
If you have a single controller unit configuration and want to mount the default
volume, proceed to Section 2.10.1 “Single Controller Unit Configuration” on
page 2-35.
■
If you have a partner group configuration and want to mount the default volumes,
skip to Section 2.10.2 “Partner Group Configuration” on page 2-37.
Note –
If you are creating new volumes or changing the volume configuration, you
must first manually rewrite the label of the previous volume using the
autoconfigure
option of the
format(1M)
utility. Refer to the Sun StorEdge T3 Disk
Tray Administrator’s Guide for more information on this procedure.
Note –
The default configuration does not include a hot spare. If you want to add a
hot spare to the configuration, you must remove the existing volume and re-create
the configuration. Refer to the Sun StorEdge T3 Disk Tray Administrator’s Guide for
information on adding a hot spare.
d1 d2 d3 d4 d5 d6 d7 d8 d9