Sun Microsystems Sun Quad, User Manual

Page: 21 / 62

Chapter 2 Installing the Adapter 7
Verifying the Installation
After you have installed the Sun Quad FastEthernet PCI adapter, but before you boot
your system, perform the following tasks to verify the installation. Refer to the
Solaris 2.x Handbook for SMCC Peripherals manual or your Solaris documentation for
the detailed instructions.
1. Power on the system, and when the banner appears, press the Stop-A keys to
interrupt the boot process and to get to the
ok
prompt.
2. Use the
show-devs
command to list the system devices.
You should see lines in the list of devices, similar to the example below, specific to
the Sun Quad FastEthernet PCI adapter:
The
SUNW,qfe@
x
,1
entries identify the adapter’s four Ethernet devices.
Note –
If you do not see the devices listed, check that the adapter is properly seated
and, if necessary, reinstall the adapter.
Diagnostic Testing
For Sun Quad FastEthernet PCI adapter diagnostic testing, see Appendix D,
“Running Diagnostics Tests.”.
ok show-devs
...
/pci@1f,2000/pci@2/SUNW,qfe@0,1
/pci@1f,2000/pci@2/SUNW,qfe@1,1
/pci@1f,2000/pci@2/SUNW,qfe@2,1
/pci@1f,2000/pci@2/SUNW,qfe@3,1
...