6
Sun Fire X2250 Server Installation Guide • May 2008
▼
To Apply Standby Power for Initial Service
Processor Configuration
Use this procedure to apply standby power to the service processor (SP) before
initial
configuration.
Caution –
Do not operate the server without all fans, component heatsinks, air
baffles,
and the cover installed. Severe damage to server components can occur if
operated
without adequate cooling mechanisms.
1. Connect a grounded AC power cord to the AC power connector on the back
panel of the server and to a grounded AC power outlet.
In standby power mode, the Power/OK LED on the front panel flashes,
indicating
that the SP is receiving power. See
FIGURE 1-3
and
TABLE 1-2
.
FIGURE 1-3
Front Panel
2. Continue with initial software setup tasks, as described in Chapter 2.
TABLE 1-2
Front Panel
Label
Button/LED/Port
Label
Button/LED/Port
1
Locate LED
5
Optional SATA hard disk drive 0
2
Fault LED
6
USB 2.0 connectors (2)
3
Power/OK LED
7
Optional DVD drive
4
Power button
8
Optional SATA hard disk drive 1
2
1
3 4
5
6
7
8
