Sun Microsystems Sun Fire B1600 Administration, Installation Manual

Page: 18 / 98

1-4 Sun Fire B1600 System Chassis Hardware Installation Guide • August 2003
Do not remove any modules (blades, filler panels, PSUs, SSCs) from the system
chassis prior to rack installation as this may result in deformation of the chassis and
system chassis failure.
Ensure that doorways, corridors, and aisles are wide and high enough to
accommodate the system while you are maneuvering it into position.
1.3 Tools and Equipment Needed
You need the following equipment to install a Sun Fire B1600 blade system chassis:
■
A suitable host rack or cabinet.
■
The appropriate rackmount kit for the host rack or cabinet
■
Category 5 RJ-45 cabling. A maximum of 20 cables are required for a fully
populated system chassis
■
IEC power cabling. Two cables are required per system chassis
You will also need the following tools:
■
No. 2 Phillips screwdriver
■
The correct screwdriver for the rackmounting screws being attached to, and
supplied with, the host rack or cabinet
■
A cage nut insertion tool (only for racks or cabinets using caged nuts)
1.4 System Chassis Dimensions
The shipping dimensions of the Sun Fire B1600 blade system chassis are listed in
TABLE 1-1
and shown in
FIGURE 1-1
and
FIGURE 1-2
.
TABLE 1-1
System Chassis Dimensions
Dimension US Measurement
Metric
Measurement
Overall width 17.64 in. 448.0 mm
Overall width, including sacrificial lifting handles 20.08 in. 510.0 mm
Depth 26.81 in. 681.0mm