Sun Microsystems SUN BLADE 150, Service Manual

Page: 120 / 218

7-12 Sun Blade 150 Service Manual • June 2002
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
3. Remove the following from the back of the CD-ROM or DVD-ROM drive
(
FIGURE 7-7
):
■
CD-ROM or DVD-ROM drive IDE cable connector
■
Power cable connector
4. Using a No. 2 Phillips screwdriver, remove the two screws securing the CD-ROM
or DVD-ROM drive to the chassis.
5. Place your fingers on the back of the CD-ROM or DVD-ROM drive. Push the CD-
ROM or DVD-ROM drive toward the chassis front and remove it.
6. Place the CD-ROM or DVD-ROM drive on an antistatic mat.
FIGURE 7-7
Removing and Replacing a CD-ROM or DVD-ROM Drive
7.4.2 Replacing a CD-ROM or DVD-ROM Drive
Note –
Before you replace the CD-ROM or DVD-ROM drive, verify that the drive
back panel mode-select jumper is set to “CS,” “Enable Cable Select,” or “Cable
Select.”