Sun Microsystems StorEdge, Troubleshooting Manual

Page: 106 / 168

88 Sun StorEdge SAN 4.0 Release Field Troubleshooting Guide • October 2002
brocadetest
(1M)
The Storage Automated Diagnostic Environment version 2.1 has incorporated the
launching of various Brocade Silkworm switch diagnostic tests under one Storage
Automated Diagnostic Environment version 2.1 test,
brocadetest
(1M). This test is
launched within the Storage Automated Diagnostic Environment version 2.1
framework and determines the correct Brocade specific test to run, depending on
port type.
Example CLI
brocadetest
(1M)
# /opt/SUNWstade/Diags/bin/brocadetest -v -o "dev=5:172.20.67.167|passwd=
password|iterations=1000"
Called with options: dev=5:172.20.67.167|passwd=xxxxxxx|iterations=1000
Connect to 172.20.67.167
Opened 172.20.67.167
Logged into 172.20.67.167
Clear port errors: send diagClearError 5
Port errors cleared
port is in loopback mode
Running command: CrossPortTest 1000,1
Note: You should only have a loopback on port 5.
If you have more than one loopback installed,
this test may report false errors.
Test Passed
Loopback took 34 seconds to run.
Fan #1 is OK, speed is 8640 RPM
Fan #2 is OK, speed is 8760 RPM
Fan #3 is OK, speed is 8910 RPM
Fan #4 is OK, speed is 8820 RPM
Fan #5 is OK, speed is 8820 RPM
Fan #6 is OK, speed is 8820 RPM
**********************************
Detected possible bad Power supply
Power Supply #1 is absent
**********************************
Power Supply #2 is OK
Close 172.20.67.167