Sun Microsystems StorEdge D2, Installation, Operation And Service Manual

Page: 61 / 118

Chapter 3 Monitoring and Troubleshooting the Sun StorEdge D2 Array 3-11
3. On the Identify page, in the Drive Identify section, look for the device name
(
c w t x d y s z
) of the failed drive in the Device Name column.
4. Note the SCSI ID number shown in the ID column.
As described under “ESM” on page 1-11, the physical disk label on the front of the
chassis shows the relation between a drive’s SCSI ID and slot where the drive is
located. See
FIGURE 1-6
,
FIGURE 1-7
, and
FIGURE 1-8
starting on page 12 for how to
identify which SCSI ID number corresponds to the disk, depending on whether the
array is in split-bus or single-bus configuration. Alternately, you can cause the LED
to blink on the drive by following the steps in “To Find a Drive or Enclosure” on
page 3-12.
5. If you do not find the device name of the disk drive you are looking for in the
Device Name column, click the Back button and start again with Step 1 on page
10.
6. Once you find the disk drive’s device name, go to the next applicable task in the
TABLE 3-2
on page 7.
Device name SCSI ID