Sun Microsystems StorEdge 6320 System 1.0, Reference And Service Manual

Page: 97 / 176

Chapter 5 Sun StorEdge Configuration Service Software 5-27
5.3.9 Managing Initiators and Initiator Groups
Use the
sscs
commands described in these subsections to manage initiators and
initiator groups in the Sun StorEdge 6020 arrays. You can modify, create, add, and
delete initiators and initiator groups.
5.3.9.1 Modifying an Initiator
Use this command to modify or create the initiator device description. The
sscs
modify initiator
command-line syntax is shown below.
TABLE 5-24
describes the arguments associated with the
modify initiator
subcommand.
5.3.9.2 Creating an Initiator Group
Use this command to create an initiator group in a specified disk array. Do not use
spaces, commas, or special characters (
?
,
*
,
!
,
@
,
%
, or
&
) in the array or initiator group
names. After creating the initiator group, use the
add
subcommand to add devices
to it.
The
sscs create initgroup
command-line syntax is shown below.
# sscs modify -d
text
initiator
wwn
TABLE 5-24 sscs modify initiator
Command-Line Arguments
Argument Description
-d,--description
text Specifies a text description up to 16 characters long.
initiator
wwn Specifies an initiator by worldwide ame (wwn).
# sscs create -a
array-name
initgroup
initgroup-name