Sun Microsystems StorEdge 3000 Series, Installation, Operation And Service Manual

Page: 55 / 318

4-1
C H A P T E R
4
Connecting Your Fibre Channel
Array
This chapter describes procedures for cabling the Sun StorEdge 3510 FC Array and
for connecting the array to power and to network devices.
The following topics are covered in this chapter:
■
“Converting Your Front Bezel Locks So the Keys Cannot Be Removed” on
page 4-2
■
“Fibre Channel Array Connections” on page 4-5
■
“Connecting the Chassis to an AC Power Outlet” on page 4-6
■
“Connecting the Chassis to DC Power Outlets” on page 4-7
■
“Powering Up and Checking LEDs” on page 4-9
■
“Reviewing and Changing SFP Ports (Optional)” on page 4-10
■
“Port Connectivity in a Dual-Controller Array” on page 4-10
■
“Default SFP Placement” on page 4-11
■
“Changing Your SFP Configuration” on page 4-13
■
“Configuring a COM Port to Connect to a RAID Array” on page 4-14
■
“Setting an IP Address” on page 4-14
■
“Setting Up Out-of-Band Management Over Ethernet” on page 4-16
■
“Cabling to Expansion Units” on page 4-17
■
“Setting Loop IDs on Expansion Units” on page 4-20
■
“Connecting Ports to Hosts” on page 4-23
■
“Power-On Sequence” on page 4-23
Before you connect the Sun StorEdge 3510 FC Array to the network, position the Sun
StorEdge 3510 FC Array in the rack, cabinet, or other location where it will be used.