Sun Microsystems StorageTek 6140, Manual

Page: 14 / 32

Node 1 Node 2
Controller module
FIGURE 2–1
SPARC: StorageTek Array Direct-Connect Configuration
Note –
The StorageTek 6140 array houses two controllers each having four host ports. The cabling
approach is the same as shown in Figure 2–1 , but it can support up to four nodes in a direct-attach
configuration.
Node 1 Node 2
Switch Switch
Controller module
Expansion tray
FIGURE 2–2
StorageTek Array Switched Configuration
How to Install Storage Arrays in a New Cluster
Use this procedure to install a storage array in a new cluster. To add a storage array to an existing
cluster, use the procedure in
“How to Add Storage Arrays to an Existing Cluster” on page 16 .
Installing Storage Arrays
Sun Cluster 3.0 - 3.1 with StorageTek Fibre Channel RAID Arrays Manual for Solaris OS • July 2006, Revision A 14