Sun Microsystems Solaris 7 11/99, Hardware Platform Manual

Page: 125 / 224

Chapter 6 Installing the Solaris Operating Environment With the SPARCstorage Array 113
5. If you downloaded new firmware, press the
SYS OK
button on the back of the
SPARCstorage Array(s) to reset.
Note –
Before you proceed, wait for the SPARCstorage Array to complete POST.
6. Boot your system:
Note –
You have completed the new installation of the Solaris 7 11/99 operating
environment. If you would like to install disk management software, refer to your
disk management software documentation.
Scenario 3: Upgrading to the
Solaris 7 11/99 Operating Environment
If you are currently using one of the Solaris releases below and would like to
upgrade to the Solaris 7 11/99 operating environment, follow the instructions in this
section.
■
Solaris 2.3 operating environment
■
Solaris 2.4 Hardware 11/94 operating environment
■
Solaris 2.4 Hardware 3/95 operating environment
■
Solaris 2.5 operating environment
■
Solaris 2.5.1 operating environment
■
Solaris 2.5.1 Hardware: 8/97 operating environment
■
Solaris 2.5.1 Hardware 11/97 operating environment
■
Solaris 2.6 operating environment
■
Solaris 2.6 Hardware: 3/98 operating environment
■
Solaris 2.6 Hardware: 5/98 operating environment
Caution –
If you are currently running disk management software on your system,
do not follow these instructions or you may lose the data on your disks. Refer to your
disk management software documentation for instructions.
ok boot
!