Sun Microsystems Netra T4 AC100, Service And System Reference Manual

Page: 128 / 284

8-12 Netra T4 AC100/DC100 Service and System Reference Manual • August 2001
8.3.3 Installing a Removable Media Module
1. Perform the steps listed in Section 8.3.1, “Preparation” on page 8-10, as
appropriate.
2. If you are replacing an existing drive, ensure the jumper settings match those on
the drive you are replacing. Otherwise, refer to the documentation enclosed with
your drive for information about the settings.
3. To refit the DVD-R drive:
a. Slide the drive partially into the right-hand slot in the RMM drive bay.
assembly.
b. Align the SCSI connector with the port on the DVD-R drive and press the drive
into the drive bay until the connector is firmly attached.
c. Reconnect the power cable at the rear of the drive.
d. Tighten the two captive Phillips screws to secure the drive in its bay.
4. To refit the DAT drive:
a. Slide the drive into the left-hand slot in the RMM drive bay.
b. Tighten the two captive Phillips screws to secure the drive in its bay.
c. Attach the SCSI connector at the rear of the drive and lock the retaining clips
over the connector.
d. Reconnect the power cable at the rear of the drive.
5. Slide the drive bay assembly partially into the chassis.
6. Reconnect the SCSI data cable to the drives at the motherboard.
7. Reconnect the power cable to the drives at the motherboard.
8. Slide the drive bay assembly fully into the chassis until it is flush with the front
panel.
9. Refit the four Phillips screws to secure the drive bay assembly to the chassis.
10. If necessary, fit a plastic cover to any unoccupied drive bay.
11. Refit the top access cover.
See Section 5.6.3, “Fitting the Top Access Cover” on page 5-9.
12. Refit the front fascia.
See Section 5.7.2, “Fitting the Front Fascia” on page 5-11.