Sun Microsystems Netra t1 100, User And Administration Manual

Page: 44 / 154

22 Netra t1 User and Administration Guide • June 2000
Installing or Removing Hot-Pluggable
Hard Disk Drives
The hard disk drives are hot-pluggable modules. You do not need to power down
the system or remove it from the rack to install or remove hard disk drives.
1. Remove the front bezel by pressing the latch at either end.
FIGURE 4-1
Inserting Hard Disks into the Drive Bays
2. Lever out the grilles.
3. If you are:
■
Installing hard disk drives, slide the disk drive(s) into their trays in the front of
the system (see
FIGURE 4-1
). Press them firmly to ensure they are engaged with the
backplane connector.
■
Removing hard disk drives, lift the ejector latch (see
FIGURE 4-1
) at the front of
each disk drive you are removing and pull the drive out.
4. Replace the grilles and front bezel.
1
3
2
Drive 0
Drive 1
SysAdmin.book Page 22 Friday, March 30, 2001 2:38 PM