Sun Microsystems Netra t1 100, User And Administration Manual

Page: 39 / 154

Chapter 3 Using DC Power 17
FIGURE 3-3
Opening the DC Connector Cage Clamp (Screwdriver Method)
7. Feed the exposed section of the appropriate wire into that hole in the DC
connector.
FIGURE 3-4
shows which wires should be inserted into each hole in the DC connector.
FIGURE 3-4
Assembling the DC Input Power Cable
8. Repeat Step 6 and Step 7 for the other two wires to complete the assembly of the
DC input power cable.
9. Repeat Step 4 through Step 8 to create as many DC input power cables as you
need.
If you need to remove a wire from the DC connector, insert the cage clamp operating
lever or a small screwdriver into the slot directly above the wire and press down
(
FIGURE 3-2
and
FIGURE 3-3
).
Top of connector
Top of connector
–48V Return
Ground
–48V
123
SysAdmin.book Page 17 Friday, March 30, 2001 2:38 PM