Sun Microsystems Netra t1 100, User And Administration Manual

Page: 33 / 154

11
C H A P T E R
3
Using DC Power
This chapter applies only to the Netra t1 Model 100. If you have purchased a
Netra t1 Model 105, skip this chapter and go to Chapter 4 on installing the optional
hardware modules available for the Netra t1.
This chapter contains the following sections:
■
“DC Source Site Requirements” on page 12
■
“DC Connection Materials” on page 14
■
“Assembling the DC Input Power Cable” on page 15
What’s Next?
When you have followed the instructions in this chapter to assemble the DC input
power cables, go to Chapter 4 for information about installing any optional
hardware modules you need. Do not power up the system (see Chapter 7) until you
have installed the Netra t1 into a rack (see Chapter 5), connected up the cables and
set up serial connections to the system (see Chapter 6).
SysAdmin.book Page 11 Friday, March 30, 2001 2:38 PM