Sun Microsystems Netra CT 820, Service Manual

Page: 122 / 132

B-4 Netra CT 820 Server Service Manual • July 2004
Then, in a terminal window on the workstation, type:
Alternatively, you can type the following to connect to the workstation serial port
TTY B:
You should see the word
connected
as the response. For more information on
using the
tip
command, refer to the
tip
(1) man page.
Note – To disconnect the tip window, type
~.
(tilde period) at the prompt.
B.3 Using a PC Laptop
1. Get the appropriate cable(s) and adapter(s) and make the necessary connections.
Use the information in
TABLE B-3
to make the necessary connections.
2. Set the following connection parameters:
■
No parity
■
9600 baud
■
1 stop bit
■
8 bit data
# tip hardwire
# tip -9600 /dev/ttyb
TABLE B-3
Connecting a PC Laptop
CONSOLE Port on Netra
CT 820 Server Board
Adapter Cable Adapter
Serial Port on PC
Laptop
RJ-45 on the
distributed
management card RJ-45-to-DB-9 male DB-9 female-to-DB-9
female null modem Not needed DB-9 male
DB-9 male on the
rear transition card Not needed DB-9 female-to-DB-9
female null modem Not needed DB-9 male