16
Sun Fire V125 Server Installation Guide • September 2006
Clearing Your Configuration
If you want to start the power on process again, as if from a previously unused
server, you must clear the configuration of the server.
▼
To Clear the Configuration
1. At the Solaris OS prompt, type:
2. When prompted to confirm that you want to create a “blank” server, type
y
.
3. When the OpenBoot PROM prompt appears, type:
4. Follow the instructions in one of the following sections:
■
“To Configure With the Server’s Details Registered at a Name Server” on page 14
■
“To Configure Without the Server’s Details Registered at a Name Server” on
page 14
■
“To Configure a Standalone Server for the First Time” on page 15
Accessing the Sun Advanced Lights Out
Manager Software
This section contains a brief introduction to the Sun Advanced Lights Out Manager
(ALOM) software. For detailed ALOM instructions and configuration information,
refer to the
Sun Advanced Lights Out Manager (ALOM) 1.6 Administration Guide.
The ALOM software is preinstalled on the server and is ready to run as soon as
power is applied to the server. However, you need to perform some basic
configuration steps to customize the ALOM software to suit your application.
#
sys-unconfig
ok>
boot
