Sun Microsystems FASTETHERNET 6U, Installation And User Manual

Page: 60 / 106

42 Sun Quad FastEthernet 6U CompactPCI Adapter Installation and User’s Guide • June 2000
Attaching the Sun Quad FastEthernet
Interfaces to the Network
The adapter’s four FastEthernet network interfaces are controlled by the Sun Quad
FastEthernet
qfe
(1M) device driver. In order to use the adapter’s
qfe
interfaces, you
must use the Solaris
ifconfig
(1M) command to activate the interfaces and to
assign them Internet protocol (IP) addresses.
To make the interface changes persist over system reboots, you must create a
hostname.qfe
instance file for each Ethernet interface on the adapter that you plan
to use. For example, if you plan to use only two of the four Ethernet interfaces on the
adapter, you will need to create two
hostname.qfe
instance files. You must also add
both an IP address and a host name for the new Ethernet interfaces to the
/etc/inet/hosts
file.
Note –
For more information about configuring Solaris networks, refer to the Solaris
System Administration Guide, volumes 1 through 3. You can view these documents on
the
http://docs.sun.com
website.
▼
To Attach the Sun Quad FastEthernet Interfaces
to the Network
1. Log in to the server.
Refer to your server’s documentation for the correct procedure.
2. At the terminal prompt, use the
grep
command to search the
/etc/path_to_inst
file for
qfe
devices.
# grep qfe /etc/path_to_inst
"/pci@1f,0/pci@1/pci@1/pci@a/SUNW,qfe@1,1" 1 "qfe"
"/pci@1f,0/pci@1/pci@1/pci@a/SUNW,qfe@0,1" 0 "qfe"
"/pci@1f,0/pci@1/pci@1/pci@a/SUNW,qfe@3,1" 3 "qfe"
"/pci@1f,0/pci@1/pci@1/pci@a/SUNW,qfe@2,1" 2 "qfe"