Pedal Installation
Apply grease to the threads of the #22 Pedals. This will protect the threads of the pedal and the crank arm. Use pedal washers where required.Using your
hands, thread the #22 Pedals (marked for L or R) into the respective left or right crank arms by turning them toward the front of the bike.
Once the threads catch, use your pedal wrench to finish tightening down the pedals. See Figure Q.
Tighten the pedals to a minimum of 34Nm (300 in-lbs.) of torque.
Seat Adjustment
Loosen the #12 Seat Mount Quick Release and slide the #11 Seat Mount rearward on the #2 Rear Unit Right Side Assembly until in a comfortable seating
position. Adjust the seat angle by removing and reinstalling the #17 Seat Strut Pins into a new position on the seat struts if necessary.
Position the #14 Seat Frame Assembly so that when seated, your knee is slightly bent when the forward foot is in the farthest pedal position.
If you cannot extend your leg forward enough you can move the seat back frame forward to get the proper fit. Adjust #14 Seat Frame Assembly for comfort.
See Figure R.
Q
22
Handlebar Adjustment
#8 / #9 Handlebar assemblies can be rotated up or down at the stem faceplate for desired comfort. Once handlebar position is set you can now adjust the
brake and shift controls for comfort. See Figure S.
WARNING: Make sure once you have made all your handlebar, stem and control adjustments that you do not have any leg, knee or tire interfer-
ence with the handlebar or controls. Failure to do so may result in loss of control resulting in a serious or fatal accident.
S
R
