Sun Microsystems Datacenter Switch 3456, Installation Manual

Page: 93 / 125

78 Sun Datacenter Switch 3456 Installation Guide • December 2008
13. Continue synchronized rotation until great resistance is felt, then stop.
14. Verify that the line card is properly seated in the slot.
15. Give each retainer drive screw a final turn to torque.
16. Repeat Step 2 through Step 15 for each line card, installing the cards into slots
12, 10, 13, and so on as described in “Component Distribution” on page 9 .
17. Retract and secure the antitilt bar.
Line Card Administrative Commands
This section provides basic commands to administrate line cards when they are first
installed. Some commands require you to reference
TABLE 9-1
.
▼
To Enable Line Cards
●
To enable standby power and the IPMB buses for a line card, type this
command:
where slot is the slot number of the line card from
TABLE 9-1
.
When a line card is enabled, the Standby LED on that line card flashes.
TABLE 9-1
Line Card Slot Mapping
Line
card Slot
number
IPMB
Address
Line
card Slot
Number
IPMB
Address
Line
card Slot
number
IPMB
Address
Line
card Slot
number
IPMB
Address
LC5 5 8c LC11 11 98 LC17 17 a4 LC23 23 b0
LC4 4 8a LC10 10 96 LC16 16 a2 LC22 22 ae
LC3 3 88 LC9 9 94 LC15 15 a0 LC21 21 ac
LC2 2 86 LC8 8 92 LC14 14 9e LC20 20 aa
LC1 1 84 LC7 7 90 LC13 13 9c LC19 19 a8
LC0 0 82 LC6 6 8e LC12 12 9a LC18 18 a6
# enableboard lc
slot