Sun Microsystems Datacenter Switch 3456, Installation Manual, Page: 104 / 125

Chapter 10 Powering On 89
■
8 bits
■
No parity
■
1 Stop bit
■
No handshaking
2. Press the Return or Enter key several times to synchronize the connection.
You might see text similar to the following:
If you do not see the text, still progress to Step 3 .
3. Type
root
for the login name followed by the
root
password.
The
#
prompt is displayed.
Note – As shipped, the
root
password is not set and therefore not required. Press
the Enter key when prompted for the password. Refer to the Sun Datacenter Switch
3456 Administration Guide for instructions on how to set the
root
password.
▼
To Access the CMC From the Network Management
Port
To access the CMC using the network for the first time, you must first configure the
network management port through the serial management port. See
“To Access the
CMC From the Serial Management Port” on page 88 .
You can set network parameters according to the specific details of your network
configuration using the
setlanconfig
option of the
clia
command.
Note – The following procedure makes changes that do not require a reset or reboot.
1. Set the IP address for the CMC.
where xxx.yyy.zzz.www is the IP address.
shmm1500 login:
shmm1500 login: root
Password:
password
#
# clia setlanconfig 1 3
xxx.yyy.zzz.www