Sun Microsystems 817-4054-15, Servise Manual

Page: 96 / 204

6-10 Sun Fire E2900 System Service Manual • May 2006
6.2.2 Installing the Removable Media Module
1. Complete Step 1 through Step 4 in Section 6.2.1, “Removing the Removable Media
Module” on page 6-6 .
2. Open the front right door of the system.
3. Insert the removable media module partially into the system (
FIGURE 6-8
).
4. Push the removable media module fully into the system until the metal tab
engages.
5. Reconnect the disk drive power cable, SCSI data cable, SCC card reader cable, and
DVD-ROM drive data/power cable to the IB_SSC assembly (
FIGURE 6-7
).
6. Remove the wrist strap.
7. Slide the system into the system cabinet and secure it.
See Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 .
8. Retract the system cabinet stabilization bar.
9. Reattach the power input cables, AC0 through AC4.
10. Power on the system.
See Section 4.1, “Powering On the System” on page 4-1 , and refer to the system
administration manual.
6.3 Tape Drive
Caution –
Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in its ESD-safe packaging box before placing them on any surface.
Note – The tape drive has a SCSI ID of 5.
The tape drive is located in the removable media module, located at the right front
of the system (
FIGURE 6-10
).