Sun Fire X4600, Installation Manual

Page: 49 / 66

To display the SP IP address, type:
cd /SP/network
Note –
You can switch back to the SP CLI from the serial console by entering the
Esc (
key
sequence.
Connecting to the ILOM
This section describes three different procedures for connecting to the ILOM:
■
“How to Connect to the Command-Line Interface Using SSH” on page 49
■
“How to Connect to the ILOM Command-Line Interface Through the Serial Management
Port” on page 49
■
“How to Connect to the ILOM Web Interface” on page 51
▼
How to Connect to the Command-Line Interface Using SSH
■
Perform the hardware setup as described in the hardware setup documentation.
■
Apply standby power to the server by connecting AC power to the system power supply. See
“Server Connections” on page 45 for the location of the power connectors.
Connect the server to the Internet with an Ethernet cable connected to the server's RJ-45 NET
MGT Ethernet port.
See “Server Connections” on page 45 for the location of the RJ-45 NET MGT port.
Using a client system, access a command line and establish a Secure Shell (SSH) connection to
the service processor’s IP address with the following command:
ssh -l root
sp_ip_address
For example, to connect to the SP with the DHCP-assigned IP address of 129.144.82.20, type the
following command:
ssh -l root 129.144.82.20
Log in to the ILOM.
The default user name is
root
and the default password is
changeme
.
▼
How to Connect to the ILOM Command-Line Interface Through the
Serial Management Port
Use this procedure to establish a serial connection to the ILOM SP so that you can perform
initial configuration of ILOM.
■
Perform the hardware setup as described in the hardware setup documentation.
6
Before You Begin
1
2
3
Before You Begin
Connecting to the ILOM
49