sumpple S631N, Instruction Manual, Page: 7 / 46

7
blinks when data is transferred.
RJ45 Port: RJ-45/10-100 base T, connect the network cable here.
Power Jack: DC 5V/2A power supply.
RESET BUTTON: Press and hold the RESET BUTTON for 10 Seconds to reset the camera
back to the factory default settings. (Please keep the power on when doing a RESET)
1.4 PC System Requirements
System configuration requirements:
CPU:
2.06 GHZ or above.
Memory : 256M or above.
Network Card: 10M or above.
Display Card : 64M or above memory.
Recommended Operating system: Windows XP, Windows Vista, Windows 7, Windows 8,
Mac OS
1.5 Hardware Installation
Follow the steps below to set up your camera hardware.
1. Plug the power adaptor into the camera and into an AC outlet.
2. Plug the network cable into the camera and router/switch.
3. It takes approx 30 seconds to boot up the camera, then you will find the IP address from “IP
Camera Tool” (Figure 2.1.5).
4. When the power is on and the network cable is connected, the green LED on the rear panel
will stay on.
The yellow LED will keep flashing, and the Indicator LED on the front of the camera will flash.