Summit SWC1224 Owner'S Manual Download Page 3

 

 

 

DANGER!

  

Risk of child entrapment

 

Child entrapment and suffocation are not problems of the past. Junked or abandoned 

appliances are still dangerous, even if they will “just sit in the garage a few days”. 

 

Before you throw away your old wine cooler or any appliance:

  Remove the door.   

Leave the shelves in place so that children may not easily climb inside. 

 

Never allow children to operate, play with, or crawl inside the appliance. 

- SAVE THESE INSTRUCTIONS - 

 

INSTALLATION INSTRUCTIONS 

Before Using Your Appliance 

 

Remove the exterior and interior packing. 

 

Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. 
This will reduce the possibility of a malfunction in the cooling system from handling during 

transportation. 

 

Clean the interior surface with lukewarm water using a soft cloth. 

 

Install the handle on the left side of the door using the screws that are provided. 

Installation of Your Appliance 

 

This appliance is designed for free standing or built-in (fully recessed) installation. 

 

Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level 
your appliance, adjust the front leveling legs at the bottom. 

 

Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). 
Direct sunlight may affect the acrylic coating and heat sources may increase electrical 

consumption. Extremely cold ambient temperatures may also cause the unit not to perform 

properly. 

 

Avoid locating the unit in moist areas. 

 

Plug the appliance into an exclusive, properly installed and grounded wall outlet. Do not under any 
circumstances cut or remove the third (ground) prong from the power cord. Any questions 

concerning power and/or grounding should be directed toward a certified and authorized products 

service center. 

Defrosting 

While it is running, the appliance defrosts itself automatically every 8 hours. The defrosting process 

lasts about 30 minutes. The melt water collects in the evaporator drip tray where it evaporates.  

During the process of defrosting, the displayed temperature may be higher than the set temperature. 

NOTE: You may notice condensation on the outer surface of the glass door. This occurs when water 

vapor from the air contacts the cold surface of the door and the vapor condenses on the glass, 

causing a fogging effect. In extreme situations, water can even drip off the door, indicating 

excessive humidity in the environment. 

Summary of Contents for SWC1224









Reviews: