Key Lock
If no key is touched for 2 minutes, the controls will be locked automatically. To release the lock,
touch the
and symbols at the same time for at least 5 seconds.
Setting the Temperature Control
You can choose between Fahrenheit and Celsius for the temperature display by touching the
symbol. A Fahrenheit or Celsius degree indicator will appear next to the temperature display
window.
You can set the temperature by touching the
UP
and
DOWN
symbols. When you push the two
buttons for the first time, the LED readout will show the original temperature set previously. (The
temperature preset at the factory is 38°F (3°C).
The temperature you are setting will increase by one degree each time you touch the
UP
symbol, and will decrease by one degree each time you touch the
DOWN
symbol.
The range of the temperature control is from 34°F to 43°F.
To view the set temperature at any time, touch the
UP
or
DOWN
symbol. The set temperature
will flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit
will reappear in blue in the display window.
When you use the unit for the first time or restart the unit after it has been shut off for a long
time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
NOTE:
If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
Interior Light
The unit is equipped with an interior LED light which can be turned ON or OFF by touching the
symbol.
DOOR LOCK
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the
Owner’s Manual
. Insert the key into the lock
and turn it counterclockwise to unlock the door. To lock the door, do the reverse operation, making sure
the metal pin is engaged completely. Remove the key and put it in a secure place for safekeeping.
SHELVES
To prevent damaging the door gasket, make sure to have the door all the way open when pulling the
shelves out of the rail compartment.
For easy access to the stored content, you can pull the
shelf approximately halfway out of the rail
compartment. However this unit was designed with a
plastic post on each side of the shelf track to prevent
shelf contents from falling.
When removing the shelf from the inner rails, make
sure to remove all shelf contents first. Then move the
shelf to the position where the notches in the shelf are
exactly aligned with the plastic posts and lift the shelf. In order to replace the shelf, repeat this
procedure in reverse.
9
