9
C.
Drill the 2 holes shown by using a 3/16” drill bit
on the bottom of drawer door front. (Fig. 2)
D.
The overlay panels should be cut to the following
dimensions:
15.6” High
21.4” up to 24” Wide
3/4” Thick
E.
If reusing the handles that came with the unit,
drill two holes with diameter 3/16” in the overlay
panel. Attach the handle and overlay panel
together to the drawer face using 2 M4x65
screws and through the upper 2 existing holes
inside the door groove. Then attach the overlay
panel to the drawer face using 2 wood screws
#10x2 (ST4x50) Type AB Phillips and through
the lower 2 existing holes inside the door groove.
(Fig. 3)
F.
If user-supplied handles will be used, attach the
handles to the overlay panels by using the flat
head screws and drive the screws flush with the
panels. Then attach the overlay panel to the
drawer face using the 4 wood screws #10x2 (ST4x50) and through the 4 existing holes
inside the door groove.
G.
Peel back the gaskets, then align the left and right slide channels with the tracks in the
cabinet. Ensuring an even track engagement on both sides, gently push the drawer into the
cabinet until it stops.
3.
To replace the stainless steel panel, which was installed on your unit, follow the steps below:
A.
Remove all the screws (4) and washers (3) attaching the stainless steel handle (1) from the
stainless steel door panel (2).
B.
Fix the brackets (6) to the door panel (2) with screws.
C.
Align the holes of the stainless steel panel with the brackets on the door panel.
D.
Tighten the bracket screws into your stainless steel panel.
E.
Reattach the stainless steel door handle (1), using the supplied screws (2) and washers (3).
Summary of Contents for FF12DROS24
Page 5: ...5 LOCATION OF PARTS...
