Summit CP36BK, Instruction Manual

Page: 6 / 16


Do not under any circumstances cut or remove the third ground prong from
the power cord supplied.

Plug the appliance into an exclusive, properly installed grounded wall outlet.
Any questions regarding power and/or grounding should be directed toward a
certified electrician or an authorized Summit service center.

It is recommended that a separate circuit serving only this appliance be
provided. Use a receptacle that cannot be turned off with a switch or pull chain.

The use of extension cords is strongly discouraged.

This appliance requires a standard 115/120-volt, 60 Hz electrical outlet with
three-prong ground and a 15-amp fuse. To prevent accidental injury, the
power cord should be secured behind the appliance and not left exposed or
dangling.
NOTE: Before performing any type of installation, cleaning or removing a light
bulb, turn the temperature control to OFF and then disconnect the unit from
the electrical power source. When you are finished, reconnect the refrigerator
to the power source and reset the temperature control to the desired setting.
Reversing the Door Swing of Your Appliance
This appliance has the capability of opening either from the left or the right side.
Should you desire to reverse the opening direction, follow these instructions.
CAUTION: To avoid injury to yourself and/or property, have someone assist you
during the door reversal process.
To access the lower hinge
assembly, tilt the refrigerator
backward. You should rest
it on something solid, e.g., a
chair, just below the top
panel.
DO NOT lay the appliance
completely flat as this may
damage the coolant system.
Remove both legs located
at the front of the cabinet:
adjustable leg on hinge side
and fixed leg on opposite
side.
Remove the screws holding the lower hinge assembly to the cabinet.
Remove the main door assembly from the refrigerator cabinet by opening the
door and pulling down.
5