SWIFTREE SECTION ASSEMBLY
Step 1.
Insert the swaged end of the bottom section into the
open end of one of the remaining sections as shown in
figure 4.
Step 2
. Repeat
Step 1
for the other ladder sections. Double check
to insure that all three stand-off brackets are facing the same
direction before use.
See figure 5.
PG 3
WARNING
!
ALWAYS ENSURE that the U-shaped stand-off
brackets on each section are an the same side once
assembled.
ALWAYS ENSURE that the sections are fully slid
together so each end contacts the rivet stop point
before climbing.
1.5” Bolt
Locknut
2
3
NOTICE
The Lower Ladder Section has an oval shaped wire
ring welded to the base. It should be the only section
with this ring. It must always be used as the bottom /
ground level ladder section
Swaged End
4
5
