Summit AZRF7W, User Manual

Page: 8 / 16

8
2. Set the Temperature Control Knob at the MAX position and let the unit operate for 20 minutes.
The freezer compartment should get slightly frosted, and the motor should run smoothly with a
soft hum.
3. Rotate the Temperature Control Knob counterclockwise toward the MIN position. Before the
pointer of the knob reaches the MIN position, the motor should turn off.
NOTE:
This appliance is equipped with a special Thermostat Control Device. If the unit is turned off
or unplugged, YOU MUST ALLOW THREE (3) MINUTES BEFORE RESTARTING OR
REPLUGGING THE UNIT. The unit will not start if you attempt to restart it in less than three
minutes.
Electrical Connection
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a
three-prong plug which mates with a standard three-prong wall outlet to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This unit requires a standard 115-volt AC/60Hz electrical outlet with three-prong ground. Have the
wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the unit and not left exposed or
dangling.
The unit should always be plugged into its own individual electrical outlet which has a voltage rating that
matches the rating label on the appliance. This provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard from overheated wires. Never unplug
the unit by pulling on the power cord.
Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately
any power cord that has become frayed or otherwise damaged. Do not use a cord that shows cracks
or abrasion damage along its length or at either end. When moving the unit, be careful not to
damage the power cord.
Extension Cord
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.