7
UNIT REVIEW & INSPECTION
This refrigerator was completely inspected before leaving the factory. Check for signs of damage when
the unit is received. If there is any damage, contact your authorized distributor or manufacturer
immediately. Check that the following accessories are included with your refrigerator:
6 plastic (polycarbonate) shelves (packed in plastic wrap inside unit cabinet)
24 shelf clips (packed separately in a plastic bag inside the cabinet)
INSTALLATION INSTRUCTIONS
This model is designed for interior use at a maximum operation temperature of 80.6°F (27°C) and 55%
humidity. It is meant to be free-standing and not built into an enclosure.
Do not place the unit near heat sources such as stoves, grills, radiators, etc. and do not place in areas
where direct sunlight may reach the unit.
LOCATION
It is recommended that the rear portion and both sides of your refrigerator be at least 8 inches and 6
inches from the wall respectively, to allow air flow to the compressor and improve heat transfer.
Place your refrigerator on a level surface.
Minimum Distances
Once the unit is installed, check that it is level. If necessary, use the two front legs to adjust the height of
the unit.
CAUTION
:
This appliance is designed for storing and cooling pharma-
ceuticals, vaccines and other medical specimens. Do not use it to store
perishable food or chemical substances like solvents and reagents.
CAUTION:
After unpacking you
MUST
allow this appliance to stand upright for at least 2
hours to allow the lubricant and refrigerant to drain back into the compressor and
stabilize. Failure to do so may adversely affect performance and the lifetime of this unit.
